Objective: Gain experience configuring standard access lists.

　　Lab Equipment: Router 1, Router 2, and Router 4 from the eRouters menu

　　Background Reading: Lab Primer Lesson 10: Access Lists

　　If you feel confident about configuring IP addresses and RIP, establish the configuration in the table below, and then continue with step 10.

　　1. Connect to Router 1, assign it a host name of Router1, and set the IP address on the Ethernet 0 interface to 24.17.2.1 255.255.255.240. Set the IP address on the serial 0 interface to 24.17.2.17 255.255.255.240. Remember to enable both interfaces.

　　Router> enable

　　Router#config t

　　Router(config)#hostname Router1

　　Router1(config)#interface ethernet0

　　Router1(config-if)#ip address 24.17.2.1 255.255.255.240

　　Router1(config-if)#no shutdown

　　Router1(config-if)#exit

　　Router1(config)#interface serial0

　　Router1(config-if)#ip address 24.17.2.17 255.255.255.240

　　Router1(config-if)#no shutdown

　　Router1(config-if)#exit

　　Router1(config)#exit

　　2. Connect to Router 2, assign it a host name of Router2, and set the IP address on the Ethernet 0 interface to 24.17.2.2 255.255.255.240. Remember to enable the interface.