Objective: Gain experience configuring extended access lists.

　　Lab Equipment: Router 1, Router 2, and Router 4 from the eRouters menu

　　Background Reading: Lab Primer Lesson 10: Access Lists

　　1. If you have just completed Lab 28: Verifying Standard Access Lists, then all you need to do is execute the no ip access-group 1 in command on the Ethernet 0 interface of Router2, and then start this lab at step 10.

　　Router2>enable

　　Router2#conf t

　　Router2(config)#interface ethernet0

　　Router2(config-if)#no ip access-group 1 in

　　Note: If you have not completed Lab 28: Verifying Standard Access Lists and you feel confident about configuring IP addresses and RIP, establish the configuration in the table below and then continue with step 10.

　　2. Connect to Router 1, assign it a host name of Router1, and set the IP address on the Ethernet 0 interface to 24.17.2.1 255.255.255.240. Set the IP address on the serial 0 interface to 24.17.2.17 255.255.255.240. Remember to enable both interfaces.

　　Router>enable

　　Router#conf t

　　Router(config)#hostname Router1